Skip to Main Content Skip to Footer Content

HouseMaster® Blog

Tips

Before You Turn on the Heat: 8 Things Homeowners Should Check This Fall

A short walk-through before the first cold night can prevent a mid-winter breakdown and catch safety hazards early. The eight things to check are the furnace, air filters, vents and registers, thermostat, flue and venting, carbon monoxide (CO) detectors, exposed ductwork, and any signs the system needs a professional.

The stakes go beyond comfort. The U.S. Consumer Product Safety Commission (CPSC) reports that more than 200 people in the U.S. die each year from CO produced by non-automotive consumer products, including malfunctioning furnaces, water heaters, and room heaters. For homeowners in Harrisburg and Lebanon, where heating systems run for months, a fall check is one of the simplest ways to protect both the household and the home.

1. The furnace and the space around it

Start with a visual check of the furnace itself. Look for rust, water on the floor, soot near the burner area, loose panels, or damaged wiring. Then clear the area around it. Basements often double as storage, and boxes, paint cans, and laundry tend to creep toward the furnace over the summer.

The U.S. Fire Administration (USFA) recommends keeping anything that can burn at least 3 feet from heat sources and having heating equipment cleaned and inspected each year by a professional.

Timing matters too. ENERGY STAR advises checking heating systems in the fall because contractors get busy once winter arrives. A professional tune-up covers items homeowners should not attempt, such as gas connections, gas pressure, burner combustion, and the heat exchanger.

2. Air filters

A clogged filter forces the system to work harder, raises energy bills, and shortens equipment life. ENERGY STAR recommends checking the filter every month during heavy-use seasons, replacing it when it looks dirty, and changing it at least every 3 months.

A few tips make this easier:

  • Write the filter size on the furnace cabinet so the next replacement is a quick buy.
  • Match the airflow arrow on the filter to the direction of airflow into the furnace.
  • Check more often in homes with pets, allergies, or ongoing renovation dust.

3. Vents and registers

Warm air needs a clear path in and out of every room. Walk through the house and check where warm air comes out and where air goes back to the furnace.

  • Move rugs, furniture, and curtains that cover or block registers.
  • Vacuum dust from register covers and the first few inches of the duct.
  • Open registers that were closed for summer.
  • Note rooms that heated unevenly last winter. A cold room can point to a blocked register, a disconnected duct, or an airflow problem worth having checked.

4. Thermostat

A thermostat that misreads the room can leave a house too cold or run the furnace more than needed. Test it before the first cold snap. Switch to heat, raise the setting a few degrees above room temperature, and confirm the furnace starts within a few minutes. Replace batteries if the thermostat uses them.

Location matters. The U.S. Department of Energy (DOE) says a thermostat should sit on an interior wall away from direct sunlight, drafts, doorways, and windows, with no furniture blocking airflow around it.

Programming pays off. The DOE estimates households can save as much as 10% a year on heating and cooling by turning the thermostat back 7 to 10 degrees Fahrenheit for 8 hours a day. Homes with heat pumps are an exception. The DOE notes that setbacks can make heat pumps run inefficiently in heating mode unless the thermostat is designed for them.

5. Flue and venting

Gas and oil furnaces send exhaust out of the house through a flue pipe and chimney or a side-wall vent. If that path is blocked, loose, or corroded, exhaust gases, including CO, can back up into the home.

Homeowners can safely look for:

  • Rust, holes, or white residue on the metal flue pipe
  • Sections that sag, separate, or look loosely connected
  • Bird nests, leaves, or debris at the chimney top or exterior vent
  • Plastic vent pipes (on high-efficiency furnaces) that are cracked, disconnected, or blocked by snow, mulch, or landscaping
  • Soot or scorch marks around the furnace or vent connections

The CPSC recommends that a professional check chimneys and flues for blockages, corrosion, and loose or disconnected sections during an annual heating system inspection. Any visible problem here is a reason to call a professional before running the furnace.

6. Carbon monoxide detectors

CO is colorless and odorless, so a working alarm is the only reliable early warning. The CPSC recommendsinstalling CO alarms on every level of the home and outside sleeping areas, testing them monthly, and replacing batteries every year.

Before the heat goes on:

  • Press the test button on every alarm.
  • Replace batteries, or confirm plug-in and hardwired units have working battery backup.
  • Check the manufacture date. Alarms have a recommended replacement age, and newer models give an end-of-life signal.
  • Avoid placing alarms in kitchens, directly above fuel-burning appliances, or near heating vents.

Know what to do if an alarm sounds. The CPSC advises getting everyone outside to fresh air immediately, calling 911 or the fire department, and not searching for the source. Early CO poisoning symptoms, including headache, fatigue, nausea, and dizziness, often feel like the flu.

7. Exposed ductwork

Leaky ducts send paid-for heat into basements, crawl spaces, and attics instead of living spaces. ENERGY STAR estimates that in a typical house,about 20 to 30 percent of the air moving through the duct system is lost to leaks, holes, and poorly connected ducts.

Check any ductwork you can see in the basement, garage, attic, or crawl space for:

  • Joints that have separated or hang loose
  • Holes, tears, or crushed sections
  • Kinked or tangled flexible ducts
  • Old duct tape that has dried out and peeled away
  • Missing insulation on ducts running through unheated spaces

ENERGY STAR recommends sealing accessible leaks with mastic sealant or metal tape, not standard duct tape, which does not last. Disconnected or badly damaged sections are worth handing to a professional.

8. Signs the system needs professional attention

Some problems call for a qualified technician before the heating season starts, not after the first breakdown. Schedule service if you notice:

  • CO alarm activity, even a single alert. Have a qualified technician inspect fuel-burning equipment before using it again if CO is suspected.
  • Soot, scorch marks, or rust around the furnace, burners, or flue
  • Loud banging, squealing, or rattling when the system starts
  • Short cycling, where the furnace turns on and off frequently
  • Uneven heat or rooms that never reach the set temperature
  • Heating bills that rise without a change in use or rates
  • Headaches, nausea, or dizziness that ease when away from home, a possible sign of CO exposure

If you smell gas, leave the house and call the gas utility or 911 from outside. Do not switch lights or appliances on or off.

Even without warning signs, have the heating system professionally inspected and serviced every year.

Get a clear picture of the whole house before winter

A heating tune-up covers the furnace. A home inspection covers how the furnace, venting, ductwork, attic, basement, and safety devices work together. That broader view catches problems a single-system service visit can miss, such as a disconnected duct in a crawl space or a missing CO alarm outside a bedroom.

HouseMaster Serving Harrisburg and Lebanon offers home maintenance inspections for current homeowners. The inspection includes a report with recommendations for immediate and long-term repairs, so homeowners can prioritize what to fix and hand specific items to an HVAC contractor.

Buying a home this fall? A HouseMaster home inspection operates the heating and cooling system and evaluates the visible components and distribution ductwork as part of the standard report.

Inspectors Dan and Scott Ayers grew up in Pennsylvania and serve Harrisburg, Lebanon, Camp Hill, Mechanicsburg, Hershey, and surrounding communities. Head into heating season with fewer surprises. Book a home maintenance inspection or call to schedule.

HouseMaster Blog Categories

HouseMaster Blog Categories

About HouseMaster

HouseMaster offers residential and commercial inspection services through over 200 franchise locations in the U.S. and Canada. Our home inspection services provide peace of mind and transparency during the home purchase process.
Learn More
Service You Can Trust!

Let us know how we can help you today.

Find a HouseMaster Near Me

Let us know how we can help you today.

Call us at (717) 429-0378
Housemaster-Neighborly wrapped work truck with map pin.